FD-200F Pilot Freeze Dryer lyophilizer Machine, 40kg/24hours, 2 square meter

REFRIGERATION SYSTEM

• Dual-stage cooling technology easy to maintained.
• Famous brand hermetic compressor like Tecumseh (France brand) and DANFOSS (Sweden brand), low noise, and ensure powerful cooling performance.
• Danfoss brand of pressure controller and valve to ensure high stability.
• Condenser -86°C for silicone oil machine, -60°C for electric heating machine. fast cooling from +20℃ to -40℃ within 30 min.
• Shelf temperature  between -50°C to +70°C ±1°C (when it balance), Fast cooling from +20℃ to -40℃ within 60 min.
• Air-cooled machine can be work in the room without additional cooling device.
• Used CFC-FREE environmental-friendly refrigerant.
• Brazed plate heat exchanger.

DRY CHAMBER

• Rectangular type dry chamber, Pre-freezing, drying in same chamber without any manual operation.
• Drying chamber & shelves made by polished SS 304 or material contact parts SS316 is optional, adopted high strength, high transmittance plexiglass door, easy to observe, inside round corner, easy to clean.
• Roughness ≤ 0.6μm of inner wall of dry chamber and shelves,  flatness of shelves ≤ ±0.5mm / m to ensure best drying performance.
• Shelf temperature  between -50°C to +70°C ±1°C (when it balance), Fast cooling from +20℃ to -40℃ within 60 min.
• Oil circulation heating type with high temperature precision control, usually suitable for medical, bio field, electric heating type suitable for food field.
• Shelves heating system uses safe voltage, while heating rate controllable, shelf made of mirror polish stainless steel, each shelf should be tested their roughness and flatness by professional tester in order to provide uniformity temperature for sample.
• Wall-cross type is optional to meets with GMP standard.

CONDENSER (COLD TRAP)

• Large capacity condenser design, made by SS304 material, SS316 is optional for the material which has high corrosivity.
• Lowest condenser temperature reach up to -86°C for silicone oil machine, -60°C for electric heating machine.
• Fast cooling from +20℃ to -40℃ within 30 min.
• Independent Cylinder-type cold trap (FD-20F, FD-30F-TP, FD-50F-TP, FD-100F, FD-200), with high transmittance plexiglass door, powerful ice remove capacity to ensure best performance. Cooling pipe condenser for FD-10F, FD-30F-RE, FD-50F-RE, FD-50F-R model.
• Patented gas diversion technology, cold trapping ice even, ice-catching ability.
• Electric heating around the condenser chamber to remove ice effective.

CIRCULATION SYSTEM

• GUNDFOS (Denmark brand) shielded circulating pump and PID control electric heating component; circulation liquid used Low-temperature low- viscosity silicone oil.
• Circulation system is for FD-20F, FD-30F-TP, FD-50F, FD-100F, FD-200F series.

FD-LYO CONTROL SYSTEM

• Flexible manual + Auto control, manual groping process, auto batch production.
• PLC control with 7’ LCD touch graphic display, can be operated in auto, semi-auto and manual mode. (Siemens brand PLC + 10’’ touch screen is optional)
• Shelf temperature adjustable, controllable, explore suitable for pilot and production processes.
• 32 programs, each program can be set as 36 segments, curve can be stored, processing parameters can be modified in real time.
• Built with recorder, with USB interface data can be exported to computer for analysis, FD-LYO software & computer is optional for controlling by remote way.
• sensor calibration function, to ensure long-term use of the accuracy of the measured value.
• Real-time alarm display and historical alarm inquiry function, convenient fault diagnosis and equipment maintenance.
• Users can set the level and password, decentralized operation and management.
• WIFI Remote control software by computer or APP in mobile, you can set the machine in anywhere of the world. (Optional)

VACUUM SYSTEM

• Two-stage rotary vane vacuum pump, vacuum is automatic adjust and can be set (optional).
• Ultimate vacuum can reach 1 Pa, in order to reach highest vacuum, LEYBOLD/ULVAC/Edwards brand vacuum pump is optional.
• Pump performance from atmosphere to 10 Pa less than 30 min.
• System leaking rate less than 10 Pa·l / sec

SAFETY PROTECTION

• Whole machine protection.
• Operation protection like electrical system have logic interlock, control and protection function.
• Alarm for vacuum system, heating system and etc.
• Power off/on protection, sublimation process protection
• Material protection during sublimation process, Heat cutting if vacuum lack
• Condenser-vacuum system interlock protection system.

OTHER FEATURES

• Normal type suitable for bulk raw products like food, fruit, herbal medicine and bio material. Stoppering type suitable for vials comes with cap, to stoppering caps into the vials.
• Inflatable (water) valve with a safety diaphragm valve can be connected to the inert gas source, dry and filled with inert gas, to extend the shelf life of the material.
• CE/ISO 9001 13485 14001 certificated, can be conforms to GMP standard as per customer’s requirements

MAIN FEATURES

MAIN COMPONENTS LIST

SPECIFICATIONS OF FREEZE DRYING MACHINE

FD-200F Series	Model	FD-200F-R	FD-200F-TP
	Heating type	Silicone oil circulation	Silicone oil circulation
	Picture
Drying chamber	Freeze-drying area	2.25 m2	1.98 m2
	Shelves quantity	5+1pcs	4+1pcs
	Shelf Temperature	-50°C ~70°C	-50°C ~70°C
	Shelf Temp. Accuracy	± 1°C (when stable)	± 1°C (when stable)
	Shelf spacing	80mm	100mm
	Size of shelves	500*900*20 mm	610*810*20 mm
	Raw material load capacity (be better)	22L (when thickness 10mm)	20L (when thickness 10mm)
	Material of chamber	Polish SS304	Polish SS304
	Material of Shelves	Polish SS304	Polish SS304
	Material of trays	SS304	SS304
	Tray quantity	10 pcs	16 pcs
	Stoppering device	–	Hydraulic pressure
Vials load capacity	Ф22 vials (PCS)	4100	3600
	Ф16 vials (PCS)	7800	6800
	Ф12 vials (PCS)	14400	12600
Condenser	Max temperature	≤-85°C (Empty load)	≤-85°C (Empty load)
	Water-capture capability	30 Kg/24h	30 Kg/24h
	Defrost	water soaking	water soaking
	Material	SS304 or SS316 (Optional)	SS304 or SS316 (Optional)
Basic parameters	Vacuum degree	≤5 Pa	≤5 Pa (Range:1~300Pa)
	Dimension	1200*2100*1700 (mm)	2100x1400x2400 (mm)
	Max Power	13.5kw	15.5kw
	Weight	1200 kg	1500 kg
	Data Process	RS232 Interface or USB
	Control method	PLC auto + manual
Refrigeration unit	Compressor	Bitzer or TECUMSEH, 2 set
	Power	7 Kw
	Refrigerant	R507 & R23
	Cooling type	Air cooled
	Pressure controller	DANFOSS
	Expansion valve	DANFOSS

OPTIONAL LIST